<strike id="rtj1v"><dl id="rtj1v"><ruby id="rtj1v"></ruby></dl></strike><strike id="rtj1v"></strike><span id="rtj1v"><i id="rtj1v"></i></span>
<span id="rtj1v"><i id="rtj1v"></i></span>
<span id="rtj1v"></span>
<span id="rtj1v"><dl id="rtj1v"><del id="rtj1v"></del></dl></span>
<progress id="rtj1v"><video id="rtj1v"><span id="rtj1v"></span></video></progress><span id="rtj1v"></span>
<span id="rtj1v"></span>
<th id="rtj1v"><video id="rtj1v"></video></th>
<strike id="rtj1v"><i id="rtj1v"></i></strike>
<strike id="rtj1v"><dl id="rtj1v"><ruby id="rtj1v"></ruby></dl></strike>
<strike id="rtj1v"><i id="rtj1v"></i></strike><span id="rtj1v"></span>
<strike id="rtj1v"></strike>

What should you pay attention to when using a registrar?

The injection molding machine can complete the injection molding operation, but when the staff uses it, the following points should also be noted so that the safety of the production process and personal safety can be guaranteed.

If the temperature of the injection molding machine rises, then the harm that this situation gives us is still very high. For example, it can give the machine the problem of deformation. Because the coefficient of thermal expansion of the hydraulic part is different, its gap will change accordingly. This may cause malfunction of the system, and the accuracy of the hydraulic system itself will naturally affect the quality of the machine.

The increase in temperature will cause the viscosity of the oil to drop. If such a situation occurs, it will degrade all the system functions of the injection molding machine. Because of the drop in viscosity, the wear of the parts in the lubrication area will also greatly increase, causing the problem of increased wear. Excessive temperatures cause damage to parts of the rubber structure. Because if the temperature is too high, then the aging speed of the rubber is accelerated, so that its sealing performance is reduced, the service life is also reduced, and leakage accidents occur. If the temperature is too high, it may be caused by a blockage in the pipeline, such as plugging of the filter and blockage of the cooling tower.

The problems caused by excessive temperature are many. Therefore, staff must evade this problem when dealing with it, and should be dealt with promptly if any occurs. In everybody's usual operation of the machine also need to pay attention to not be able to remove a variety of safety devices, if any safety equipment errors or accidents, need to shut down the machine, before the injection molding machine restart, we must ensure that the fault has been excluded Row.


掃描二維碼分享到微信

4日本私人vps生活大片_熟妇人妻videos_男男r18禁视频同性被c哭_尤物视频网站